250 lb. Balance Technology Inc #H-250 Horizontal Balancer w/Safety Shield

Balancer Technology Inc Model# H-250 Balancer S/N: 11148 Includes: Balancing Standard Workpiece shaft support stands All Available Manuals This is a benchtop, cradle, hard bearing balancer used for Numerically Controlled manual balancing armatures and other smaller rotating parts. Includes: Manuals and Writeups with setup and specs Balancing Standard Workpiece shaft support stands <1> REPEATABILITY TEST -- Displays the test screen for recording a series of successive unbalance measurements. The test is performed by taking repeated unbalance measurements of a single part. The program will display the maximum spread for all readings and calculate the average automatically. <2> GAGE R & R -- Provides access to the "Gage R & R" screens. These screens display the readings and calculated results of the test. The user can set up the test for a set number of trials and operators. To set up the test select the EDIT PARMS button, make changes, & use GO BACK to return to the test screen. (Note: Editing parameters will clear all data.) Three test screens are provided: left plane, right plane, and force unbalance. <3> LOGGED DATA MENU -- Allows the operator to erase the logged data for incoming or outgoing parts or to copy the database to disk. Select the desired option from the menu displayed. <4> INCOMING STATS -- Displays a menu of statistical reports for incoming parts. The operator may select right and left plane, force and couple unbalance measurements for statistical analysis. l HISTOGRAM & SIMPLE STATS: Displays a bar graph showing the frequency of readings within each (predefined) range of values and the following statistical values. l TREND: Provide access to the trend graphs for current measurements. Graphs show unbalance readings on a time scale. l X_BAR & R_BAR: Provides a graphic display of the average values for groups of several readings each, and of the range for each group. l PRINT MEASUREMENT DATA: Displays the incoming data in the format shown below and allows the operator to send the data to the printer. <5> OUTGOING STATS -- Same as above but using data for outgoing parts. <6> EDIT STATS PARAMETERS -- Allows user to set certain parameters used in computing the statistical displays